1" TO 3/4" ADAPTER CUFF

Layer 0@0,25x.png
IMG_3677@0,25x.png
IMG_3682@0,25x.jpg
cuffs3.jpg
cuffs4.jpg
Layer 0@0,25x.png
IMG_3677@0,25x.png
IMG_3682@0,25x.jpg
cuffs3.jpg
cuffs4.jpg

1" TO 3/4" ADAPTER CUFF

$12.00

Required to use Lightspeed blade

Color:
Quantity:
Add To Cart
 

The Lightspeed adapter cuff allows your 3/4" Lightspeed blade to fit into any 1" ID hilt. It is made from polycarbonate and is reusable from blade to blade. A layer of nonpermanent adhesive is sprayed on the inside to enhance binding.

USE INSTRUCTIONS

To install:

  1. Partially insert a blade into the adapter.

  2. Press the blade down onto a firm, flat surface to fully seat the adapter onto the blade.

  3. Insert the adapted blade into your hilt.

  4. Orient the adapter such that the adapter slot is about 90 degrees around from your set screw(s).

  5. Tighten your set screw(s).

  6. Try to twist the blade to ensure it is properly fastened. If it twists, tighten your screws some more.

Tie your set screws about 90 degrees around from the slot.

Tie your set screws about 90 degrees around from the slot.

To remove:

  1. With one hand, grip the blade tightly.

  2. With the other hand, pry the adapter off the blade with your fingertips or fingernails inserted into the slot. You should hear a “cracking” sound if you have done this correctly. This is the sound of the adhesive pulling away. Nothing is wrong with your blade or adapter.

  3. Turn the blade in the opposite direction and pull it out of the adapter.

Do NOT grip the whole adapter in your hands or you will make removal more difficult.

Do NOT grip the whole adapter in your hands or you will make removal more difficult.